The Screen Selection in Silica Sand Industry

The Screen Selection in Silica Sand Industry

In two month ago, we meet one customer use vibrating screen for silica sand screening, that linear screener with 4 layer deck, the aperture size is 2mm, 1mm, 0.5mm and 0.125mm.

The following is the linear vibrating screener pictures

But they meet one big trouble when use the linear vibrating screener for silica sand screening as following

1. The linear vibrating screener capacity is too little, much less than their request target capacity
2. The mesh aperture is very little, so the mesh is easy broken under vibration motion, the 0.5mm and 0.125mm mesh will break after 7 hours to 10 hours.
3. When the mesh broken, they need 5 people to spend 4 hours for the bottom layer mesh changing, that means half a day for mesh changing, it waste too long time and the total output could not meet their equest.

As last, we Mega Young Screening Technology Co.,Ltd offer them one them one solution, to use our MHG side doors acess gyratory screener to replace the existing problem vibration screener screener.

After 20 days , we install our MHG screener at site as following

The screener could change mesh from two side, and we get feedback from customer as following

1.  The MHG side doors screener’s capacity is 3 times of previous vibrating screener, and screening precision also is much higher
2. The bottom mesh service could be over 15 days, save much cost for their spare part.
3. When change mesh, only need one people to operate, and it just take about 10 mins to replace the mesh, the mesh downtime is very very short, and safe.

As one result, the customer satisfied on the gyratory screener, it could bring much more profit than the vibrating screener.